Differences

This shows you the differences between two versions of the page.

--- 3dprinting [2022/10/11 11:41]
matthews created
+++ 3dprinting [2023/01/24 12:52] (current)
matthews
@@ Line 1: / Line 1: @@
+====== Printers ======
+===== Geetech A10M ====
+  * [[https://www.geeetech.com/Documents/A10M%20User%20Manual_V2.0.pdf|Manual]]
+  * [[http://www.geeetech.com/forum/viewtopic.php?f=92&t=61760|Color Mixer Software]]
 ====== 3D Printing Problems ======
+===== Setting Z-Offset =====
+Heat your printer up to your printing temperature and allow a few minutes for it to expand and settle Reset the existing Z-offset to zero:
+M851 Z0
+Home all axes:
+G28
+Move the nozzle to the middle of the bed:
+G1 X110 Y110
+Turn off the software endstops with:
+M211 S0
+Move the nozzle down so it is just gripping a piece of standard printer paper Set the Z-offset to the displayed value. E.g. if the printer displays a Z-Value of -1.23 enter:
+M851 Z-1.23
+Store it to the EEPROM:
+M500
+MAKE SURE TO ENABLE THE ENDSTOPS AGAIN WITH:
+M211 S1
 ===== Pillowing =====
   * [[https://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide#pillowing|Pillowing]]

Project Phoenix